BDV Phantom 800 Specifiche Scaricare il pdf (Pagina 14)

INSTALLATION INSTRUCTIONS

RGB-DVI Converter Installation

8 Introduction Edition 1.02 DVI Converters: Installation & Operation Guide

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

RGB-DVI CONVERTER INSTALLATION

Figure 8 illustrates the installation of the RGB-DVI converter. The following procedure

describes the installation process.

To Install the RGB-DVI Converter

Before installing the SD-DVI converter, connect the supplied power adapter to the unit and

plug it into an AC power source. Black Diamond Video recommends the use of a surge

protector.

1 Connect 3 wire, 4 wire, or 5 wire RGB or YUV source to the DB15 HD connector labelled

“RGB/YUV”.

2 Connect the DVI output of the converter to a Black Diamond Video-tested DVI cable.

3 Connect the other end of the DVI cable directly to the Black Diamond Video digital

video processing equipment in your installation, such as the Phantom 800 or CXPS.

4 The Link LED indicator on the converter flashes green when an active connection to

the converter is established.

NOTE:

DVI Converters should be connected as close to the video source as

possible to minimize cable problems such as noise and attenuation.

FIGURE 8.

RGB-DVI Converter installation

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Nessun commento

BDV Phantom 800 Specifiche Pagina 14